Open Gym Strength and Conditioning – Functional bodybuilding

Warm-up

Upper body pull warmup (No Measure)

50/35 cal Row

-into-

6 min AMRAP

10 ring rows

5 iron cross (each side)

5 seal pose/down dog pose transitions

10 seated single arm banded rows

Strict pull-ups (8×6)

-Hands outside shoulder width

-Full grip on bar

-Start hanging with arms extended

-Chest stays up with eyes forward

-pull until chin is higher than bar

-Complete at full arm extension
8 set: 6 reps

Focus: Control should be shown across sets. Athlete should keep core engaged and avoid kipping. Band across rig is encouraged if strict reps are not possible and should be set at a height that allows for desired number of rep but no more. If using a band, make note of the hole that you are placing the back across the rig to keep consistency on resistance assistance across workouts.

Body Row on Racked Barbell (4×10)

Focus: Set up a bar at waist height. It is advised to secure the bar to the rig with bands on either side so that bar will not unrack during sets. Approach bar from inside of rig. Extend legs out and grab bar from underneath, assuming a straight line with the body from the heel to the shoulder. Pull towards the bar, making contact just below the sternum. Adjust feet as needed for correct position. Difficulty should allow for solid reps without “kipping”. Raise height of the bar to decrease difficulty. Feet can be placed on a bench or stacked plates to increase difficulty.

Bent Over Row (4×10)

4 sets: 10 reps

Focus: With a double underhand grip, deadlift bar to waist and then lower to a hang position (right above the knees) to start each set. Aim to pull with the elbows (rather than the hands) and bringing the bar to the hips (do not pull high towards the upper abdomen). Focus on getting a strong back contraction with each rep. Minimize the amount of kipping used between reps and feel the stretch in the lats/upper back when lowering the bar back to the hang position with each rep.

Supported single arm row (4×10)

4 sets: 10 reps (each side)

Supported Single Arm DB Row

standing barbell bicep curls (4×10)

4 sets: 10 reps

Focus: Stay with a weight that will allow for control and minimal kipping of reps. Keep barbell slightly in front of the body at the bottom position to keep tension on the biceps throughout set (don’t go to complete loss of tension at bottom).

4 set: Single db waiter hold curl (4×10)

Single Dumbbell Waiter Hold Curl

Focus: Using one dumbbell, grasp by one head of the dumbbell with both hands (allowing the second head to hang below the hands so dumbbell is vertical). Hand position should be so that the palms are facing more towards the sky rather than palms facing each other. Curl the dumbbell, showing control throughout.
4 sets: 10 reps

Focus: Using one dumbbell, grasp by one head of the dumbbell with both hands (allowing the second head to hang below the hands so dumbbell is vertical). Hand position should be so that the palms are facing more towards the sky rather than palms facing each other. Curl the dumbbell, showing control throughout.