Open Gym Strength and Conditioning – Functional bodybuilding

Warm-up

Upper body pull warmup (No Measure)

50/35 cal Row

-into-

6 min AMRAP

10 ring rows

5 iron cross (each side)

5 seal pose/down dog pose transitions

10 seated single arm banded rows

Strict pull-ups (6×6)

-Hands outside shoulder width

-Full grip on bar

-Start hanging with arms extended

-Chest stays up with eyes forward

-pull until chin is higher than bar

-Complete at full arm extension
6 sets: 6 reps

Focus: Control should be shown across sets. Athlete should keep core engaged and avoid kipping. Band across rig is encouraged if strict reps are not possible and should be set at a height that allows for desired number of rep but no more. If using a band, make note of the hole that you are placing the back across the rig to keep consistency on resistance assistance across workouts.

Banded lat pull-downs (4X10)

4 sets: 10 reps

Focus: On a seated lat pull machine, position body so knees are locked under the leg pad and arms are extended overhead. With an overhand grip, focus on a strong contraction of the back/pulling back with the elbow not the hands. Bar should come right below the chin to the top of the chest. Slight lean back is acceptable to get shoulders in a down and back position. If you do not have access to a lat pulldown, attach a PVC pipe to a pullup bar via two bands and perform this movement. ALWAYS INSPECT BANDS FOR SIGNS OF POTENTIAL BREAKAGE BEFORE USING.

lying DB pull overs (4X12)

Lying DB Pullover on Bench

Lying on a bench, hold a dumbbell by the upper head in both hands. Keeping a slight bend in the arms, lower the dumbbell back towards the floor. Engagement should be felt in the lats/upper back. Only go back as far as control in the lift is still felt and start light to get a feel for the movement. Avoid overarching the back to facilitate a greater range of motion; core should remain engaged throughout. Suggested lying on the bench sideways so the upper back is the supported area by the bench (just ensure that bench is secured to prevent tipping over).
4 sets: 12 reps

Focus: Lying on a bench, hold a dumbbell by the upper head in both hands. Keeping a slight bend in the arms, lower the dumbbell back towards the floor. Engagement should be felt in the lats/upper back. Only go back as far as control in the lift is still felt and start light to get a feel for the movement. Avoid overarching the back to facilitate a greater range of motion; core should remain engaged throughout. Suggested lying on the bench sideways so the upper back is the supported area by the bench (just ensure that bench is secured to prevent tipping over).

Supported single arm row (4X10)

4 sets: 10 reps (each side)

Focus: Using the freehand to support the body against a bench or other elevated surface, stagger the feet, and lean forward to 45 to 80 degree angle of the torso. Athlete will pull with elbow. Focus on pulling DB to the hip/waist rather than pulling high towards upper abdomen

tricep dips (4×10)

4 sets: 10 reps

Focus: Dips can be performed on either dip bars or two high boxes (allowing the body to pass between the boxes). Keep shoulders in an engaged position throughout the dips and the rest of the body in a strong “hollow position” if not using assistance. A band can be attached across the bars or one foot can be placed on the floor to assist.

single arm tricep ext with band (4×10)

4 sets: 10 reps (each side)

Focus: Resistance should allow for control throughout the extension. ALWAYS INSPECT BANDS FOR SIGNS OF POTENTIAL BREAKAGE BEFORE USING. Avoid going to complete lockout at the bottom: focusing on stopping just before full extension. Focus on engagement of triceps with each rep and stop before failure is reached. Keep free hand behind tricep to stabilize arm and minimize swing. Rest 90 sec between.