Open Gym Strength and Conditioning – Functional bodybuilding

Warm-up

Shoulder and glute warmup (No Measure)

Crossover Symmetry

and

Hip Halo Warmup

Athletes Notes

Focus: Move with intention and focus on each movement you are performing

Shoulder Press (6×5)

6 sets: 5 reps

Focus: Take barbell from the rig. Keep abs and glutes engaged to prevent over-extension of the low back. Use a slightly staggered stance if needed to prevent over extension. Barbell should make contact with the upper chest/shoulders between reps but you should not lose tension between reps by resting the bar in the front rack. Attempt to add a small increase from previous week’s loading.

standing single arm db shoulder press (4×10)

4 sets: 10 reps (each side)

Focus: Hold a dumbbell in one hand, press overhead to full lockout. To not lean towards or away from loaded side, but aim to keep body as balanced as possible while being under isolateral load. For comfort in range of motion, dumbbell can come to the shoulder in more of a neutral grip position and finish in a pronated grip overhead (similar to an Arnold press motion without the full supinated grip at the shoulder).

standing db lateral raises (4×10)

GHD hip raise (5×20)

5 sets: 20 reps; unloaded or holding a plate or DB

GHD Hip Raise

Single leg db Romanian Deadlifts (4×10)

4 sets: 10 reps (each side)

Focus: Holding dumbbells in each hand, stand on one foot. Bend at the waist and allow the non-working leg to extend backwards for counter balance. Working leg should have a slight bend throughout rep. Continue forward with the dumbbells until the upper/lower back begins to round or right before contact is made with the dumbbells and the floor (whichever comes first). Aim for this movement is level, balance movement throughout rep (no leaning to left or right) and control of body and dumbbells throughout rep. Do not sacrifice either of these for an increase in weight. To stand, contract the glute on the working side. Consider using straps during this movement so that grip is not a limiting factor for sets. This movement can also be performed at bodyweight with no dumbbells if preferred.

banded pull through (4×15-20)

4 sets: 15 – 20 reps

Focus: Attach a moderate/heavy weight band to a rig at knee height. Turn away from the rig and grasp the band with each hand with a thumb forward grip between the legs. Step forward and lean forward slightly when the band is under tension. Hinge by pushing the hips back and then forcefully contract the glutes to drive the hips forward to full extension. ALWAYS INSPECT BANDS FOR SIGNS OF POTENTIAL BREAKAGE BEFORE USING.