Open Gym Strength and Conditioning – Functional bodybuilding

Warm-up

Upper Body Posterior (Back & Triceps) (No Measure)

3 Rounds

15/12 cal row

10 scap pullups

15 bent over barbell rows (empty bar)

5 iron cross (each side)

5 down dog/seal pose transitions

Strict pull-ups (5×8)

-Hands outside shoulder width

-Full grip on bar

-Start hanging with arms extended

-Chest stays up with eyes forward

-pull until chin is higher than bar

-Complete at full arm extension
5 sets: 8 reps

Focus: Control should be shown across sets. Athlete should keep core engaged and avoid kipping. Band across rig is encouraged if strict reps are not possible and should be set at a height that allows for desired number of rep but no more. If using a band, make note of the hole that you are placing the back across the rig to keep consistency on resistance assistance across workouts.

reverse grip lat pulldown (4×10)

4 sets: 10 reps

Focus: On a seated lat pull machine, position body so knees are locked under the leg pad and arms are extended overhead. With an underhand grip, focus on a strong contraction of the back/pulling back with the elbow not the hands. Bar should come right below the chin to the top of the chest. Slight lean back is acceptable to get shoulders in a down and back position. If you do not have access to a lat pulldown, attach a PVC pipe to a pullup bar via two bands and perform this movement. ALWAYS INSPECT BANDS FOR SIGNS OF POTENTIAL BREAKAGE BEFORE USING.

Supported single arm row (4×10)

4 sets: 10 reps (each side)

Focus: Using the freehand to support the body against a bench or other elevated surface, stagger the feet, and lean forward to 45 to 80 degree angle of the torso. Athlete will pull with elbow. Focus on pulling DB to the hip/waist rather than pulling high towards upper abdomen4x

lying DB pull overs (4×10)

Lying DB Pullover on Bench

Lying on a bench, hold a dumbbell by the upper head in both hands. Keeping a slight bend in the arms, lower the dumbbell back towards the floor. Engagement should be felt in the lats/upper back. Only go back as far as control in the lift is still felt and start light to get a feel for the movement. Avoid overarching the back to facilitate a greater range of motion; core should remain engaged throughout. Suggested lying on the bench sideways so the upper back is the supported area by the bench (just ensure that bench is secured to prevent tipping over).
4 sets: 10 reps

Focus: Lying on a bench, hold a dumbbell by the upper head in both hands. Keeping a slight bend in the arms, lower the dumbbell back towards the floor. Engagement should be felt in the lats/upper back. Only go back as far as control in the lift is still felt and start light to get a feel for the movement. Avoid overarching the back to facilitate a greater range of motion; core should remain engaged throughout. Suggested lying on the bench sideways so the upper back is the supported area by the bench (just ensure that bench is secured to prevent tipping over).

standing tricep db french press (4×10)

4 sets: 10 reps

Focus: In a standing position, take one dumbbell and hold it by the upper DB head with arms extended overhead. Keeping the elbows tucked and pointed at the ceiling, lower the weight behind the head. Extend back overhead to complete. Be sure to keep core engaged and avoid overextension in the low back.

single arm db kickback (4×10)

4 sets: 10 reps (each side)

Focus: Support one side of the body by leaning over and placing knee and hand on flat bench. Back should be straight. Hold dumbbell in free hand and bring upper arm to the side of the body. Extend the arm at the elbow until full extension has been reached. Upper arm should stay in place the entire rep.