Open Gym Strength and Conditioning – Functional bodybuilding

Warm-up

Upper body pull warmup (No Measure)

50/35 cal Row

-into-

6 min AMRAP

10 ring rows

5 iron cross (each side)

5 seal pose/down dog pose transitions

10 seated single arm banded rows

Strict pull-ups (6×5)

-Hands outside shoulder width

-Full grip on bar

-Start hanging with arms extended

-Chest stays up with eyes forward

-pull until chin is higher than bar

-Complete at full arm extension
6 sets: 5 reps

Focus: Control should be shown across sets. Athlete should keep core engaged and avoid kipping. Band across rig is encouraged if strict reps are not possible and should be set at a height that allows for desired number of rep but no more. If using a band, make note of the hole that you are placing the back across the rig to keep consistency on resistance assistance across workouts.

Bent Over Row (4×10)

4 sets: 10 reps

Focus: With a double overhand grip, deadlift bar to waist and then lower to a hang position (right above the knees) to start each set. Aim to pull with the elbows (rather than the hands) and bringing the bar to the hips (do not pull high towards the upper abdomen). Focus on getting a strong back contraction with each rep. Minimize the amount of kipping used between reps and feel the stretch in the lats/upper back when lowering the bar back to the hang position with each rep.

Double db prone row (4×10)

Double DB Prone Row

Raise the height of a bench on either side so that athlete can lay face-down on a bench and extend arms to the floor without making contact with ground. Grasp a dumbbell in each hand and pull with the elbows, focusing on a strong contraction at the top of each rep.
4 sets: 10 reps

Focus: Raise the height of a bench on either side so that athlete can lay face-down on a bench and extend arms to the floor without making contact with ground. Grasp a dumbbell in each hand and pull with the elbows, focusing on a strong contraction at the top of each rep.

straight arm lat pulldown (4×10)

4 sets: 10 reps

Focus: With a lat pulldown bar, assume a standing position and lean forward slightly. Grasp the bar at shoulder width apart and press the bar down towards the hips with straight arms. Activation should be felt in the lats. If you do not have access to a lat pulldown, perform this movement by attaching two bands to a pull-up bar and place a pvc pipe through them. ALWAYS INSPECT BANDS FOR SIGNS OF POTENTIAL BREAKAGE BEFORE USING.

Barbell skull crushers (4×10)

4 sets: 10 reps

Focus: Lie on a bench with barbell extended towards the ceiling. Movement works best with an EZ curl bar but a straight will work as well. Keeping the elbow tucked, bring the bar down towards the top of head (around the hairline region). Elbows should stay pointed towards the ceiling. Adjust grip as needed to find the best balance between comfort and power. Do not sacrifice form for weight and focus on a solid contraction with each rep.

standing tricep extension w/ band (4×15)

4 sets: 15 reps

Focus: Attach band to pullup bar overhead. ALWAYS INSPECT BANDS FOR SIGNS OF POTENTIAL BREAKAGE BEFORE USING. Resistance should allow for control throughout the extension. Avoid going to complete lockout at the bottom: focusing on stopping just before full extension. Focus on engagement of triceps with each rep and stop before failure is reached. Torso should be slightly bent forward arms/elbows slightly in front of body